Kinetics Noise Control - Vibration Isolation, Room Acoustics, Seismic Restraint Your source for Noise, Acoustic, Vibration and Seismic control systems, 1-877-457-2695
Home > Vibration Isolation for HVAC Systems > Isolation Hangers > Model FH


Fibergalss Isolation Hanger

Model FH

Fiberglass Isolation Hanger


Kinetics Model FH hangers are recommended for use in isolating high frequency noise produced by suspended equipment, piping, and ductwork. FH Hangers incorporate a coded, molded, inorganic fiberglass isolation pad attached to a steel load transfer plate and to a stamped or welded hanger bracket. Hangers will allow a support rod misalignment through a 30 arc. Isolation brackets will carry 500% overload without failure. Fiberglass pads are fine (00027" diameter/6.8 microns) bonded annealed glass fibers which are stabilized by severely overloading the material during manufacture, and then coated with a flexible moisture-impervious elastomeric membrane. Fiberglass is unique in that the natural frequency is constant over a wide operating load range, and the stiffness increases proportionately with load applied. Model FH fiberglass Isolation Hangers are available in sizes with capacities from 250 to 900 lbs. (113 to 408 kg), with deflection of 0.18 to 0.27" (5 to 7 mm). Kinetics Model FH hangers are recommended for the isolation of vibration produced by suspended mechanical or electrical equipment, in-line and exhaust fans, ductwork, piping, etc.


Kinetics Model FH hangers are recommended for use in isolating any suspended source of audible frequency vibration, or noise, located near a critically quiet area.

Isolation of noise in piping and ductwork systems from a building structure is a typical use of Model FH hangers. Piping within 100 pipe diameters of connection to mechanical equipment should be isolated with Model SFH spring and fiberglass hangers to control transmission of low frequency vibration as well as noise.

High sound transmission loss ceiling systems can be effectively isolated by Model FH hangers. When isolating sources of predominately low frequency noise such as flyover aircraft, Model SFH hangers are recommended.

Model FH hangers are shipped fully assembled and ready for installation in threaded rod suspension systems.


Vibration isolators with maximum static deflection requirements under the operating load conditions not exceeding 0.27" (7 mm) shall be hangers consisting of a precompressed molded fiberglass insert, complete with load transfer plate and assembled in a stamped or welded steel bracket.

The fiberglass insert shall be individually coated with a flexible, moisture-impervious elastomeric membrane. The insert shall be molded from glass fibers with fiber diameters not exceeding .00027" (6.8 microns) and with a modulus of elasticity of 10.5 million PSI (738,223 kg/cm2).

Natural frequency of fiberglass vibration isolators shall be essentially constant for the operating load range of the supported equipment. Vibration isolators shall be coded to indicate load capacity.

The hanger bracket shall be designed to carry a 500% overload without failure and to allow a support rod misalignment through a 30 arc without metal-tometal contact or other short circuit.

Isolation hangers shall be selected by the manufacturer for each specific application to comply with deflection requirements as shown on the Vibration Isolation Schedule or as indicated on the project documents.

Vibration isolation assembly shall be Model FH, as manufactured by Kinetics Noise Control, Inc.

Model FH Fiberglass Hanger
Dimensions and Capacities
Requires Adobe Reader 250A/500A Requires Adobe Reader 250A/500A(m)
Requires Adobe Reader 900C Requires Adobe Reader 900C(m)
Pricing and Quotations
 Tell a Friend